Woodworking

Oily Rags and Spontaneous Combustion

Rags wet with linseed oil can heat themselves until they burst into flame, hours after you've left the shop; spread them flat to cure or seal them under water in a metal can, every time.

  • 4 min
  • 5 steps
  • 3 questions
  • Lesson 96 of 160

In this lesson

  1. It really happens
  2. Why it happens
  3. What to do, every time
  4. The same goes for
  5. What to take from this

It really happens

Spontaneous combustion of oily rags is not folklore. The National Park Service describes a case where a crew’s rag soaked with linseed oil ignited despite precautions 1, and the Wood Handbook carries an explicit caution: sponges, cloths, and paper towels wet with oil-based stain, any other oil or oil-alkyd, or urethane finish are “particularly susceptible to spontaneous combustion” 2. Fires from oily rags burn down shops, garages, and houses every year, often hours after the work was finished and everyone has gone to bed.

Why it happens

Drying oils cure by reacting with oxygen, and that reaction gives off heat 3. On a tabletop the heat escapes harmlessly. But a rag holds a thin film of oil spread over an enormous surface area, with plenty of air in its fibers, so the reaction runs fast. Crumple that rag into a ball, or pile several in a bucket or trash can, and the heat has nowhere to go. As the temperature rises, the reaction speeds up, which makes more heat. Eventually the rags reach their ignition point and burn.

Linseed oil (raw or boiled), tung oil, oil-based stains, Danish and “tung oil” finishes, oil-based varnishes and polyurethanes, and linseed oil paint all carry this risk. Even cooking oils can do it in large quantities. Water-based finishes don’t.

Quick check

Why can a wad of linseed-oil rags catch fire on its own?

What to do, every time

Pick one method and make it automatic:

  1. Under water, in metal. Put rags in a metal can, fill it with water, and close the lid. Water cuts off the oxygen and absorbs heat. The Wood Handbook’s instruction is to immerse them in water and seal them in a water-filled, airtight metal container immediately after use 2. Dispose of the can through your local hazardous waste program or once the oil has hardened, as your municipality allows.
  2. Spread flat to cure. For home projects, the National Park Service recommends spreading the rags in a single layer on concrete, out of direct sunlight, with the corners weighted against wind, until they’re stiff and brittle 1. Once fully hardened, they’re inert. Hanging rags individually over a line outdoors works the same way.
  3. Approved containers. Shops using a lot of rags should use a listed oily-waste can, a self-closing metal can designed for this, and have it emptied regularly.

Never:

  • toss oily rags in a trash can, bucket, or cardboard box;
  • stuff them in a plastic bag;
  • leave them in a pile on the bench “until later”;
  • throw them in a dryer, or wash and dry oil-soaked shop towels in a home dryer.
A loop showing oil oxidizing and giving off heat, a crumpled rag trapping it, the reaction speeding up, and ignition; three safe habits and a list of never-dos.
The heat loop in a pile of oily rags, and the habits that break it. Credit: StudyCorner diagram after the Wood Handbook and the National Park Service · CC BY 4.0 · Source

Quick check

You finish oiling a table. Which is a safe way to deal with the rags?

The same goes for

  • Paper towels and sanding dust soaked with oil finish.
  • Steel wool used with oil finishes; steel wool can also self-heat.
  • Wood shavings and sawdust that have absorbed oil.
  • Brushes are less risky, but store them in oil or clean them; don’t wrap oily brushes in rags.

What to take from this

Curing linseed and other drying oils give off heat; a crumpled pile of oily rags traps it until they ignite, sometimes hours later. Every time, either seal the rags under water in a metal can or spread them flat, one layer, outdoors on concrete until stiff. Never put them in the trash, a bag, or a heap.

Practice

Which is a safe way to deal with oily rags at the end of the day?

Lesson complete

Nice work.

1day streak
0/1today's goal
–correct

Up next · 4 min

How Milk Paint Works

Next lesson
Sources for this lesson
  1. 1
    Fire Prevention 52: Spontaneous Combustion - Fact or Fiction?. National Park Service. verifiedAn NPS crew's linseed-oil rag ignited; spread rags in a single layer on concrete to dry, or use an approved container.
  2. 2
    Finishing Wood (Wood Handbook, Chapter 16). USDA Forest Service, Forest Products Laboratory, FPL-GTR-282. 2021. verifiedWeathering and UV damage to lignin, sunburned wood and the tape test, paint versus penetrating finishes, drying and nondrying oils, food-contact finishes, and the spontaneous-combustion warning for oily rags. Cited at: Penetrating Stains.
  3. 3
    Bob Flexner. Understanding Wood Finishing: How to Select and Apply the Right Finish. 3rd revised ed. Fox Chapel Publishing. 2021. verifiedThe standard reference on finish chemistry and practice - drying oils and driers, shellac cuts, waxes, and what each finish can and can't do. Cited at: Oil Finishes.